Some hypothetical alloy is composed of 25 wt% of metal A and 75 wt% of metal B. Some hypothetical alloy is composed of 25 wt% of metal A and 75 wt% of metal B. If the densities of metals A and B are 6.17 and 8.00 g/cm3, respectively, whereas their respective atomic weights are 171.3 […]
One slip system for the HCP crystal structure is {0001} One slip system for the HCP crystal structure is {0001} . In a manner similar to Figure, sketch a {0001}-type plane for the HCP structure and, using arrows, indicate three different slip directions within this plane. You might find Figurehelpful.
On the basis of the structures presented in this chapter, On the basis of the structures presented in this chapter, sketch repeat unit structures for the following polymers: (a) Polychlorotrifluoroethylene, And (b) Poly (vinyl alcohol).
One of the procedures in the production of integrated circuits One of the procedures in the production of integrated circuits is the formation of a thin insulating layer of SiO2 on the surface of chips (see Figure 18.26). This is accomplished by oxidizing the surface of the silicon by subjecting it to an oxidizing atmosphere […]
One integrated circuit design calls for the diffusion of One integrated circuit design calls for the diffusion of arsenic into silicon wafers; the background concentration of As in Si is 2.5 x 1020 atoms/m3. The predeposition heat treatment is to be conducted at 1000째C for 45 minutes, with a constant surface concentration of 8 x […]
One integrated circuit design calls for diffusing boron into One integrated circuit design calls for diffusing boron into very high purity silicon at an elevated temperature. It is necessary that at a distance 0.2 ?m from the surface of the silicon wafer, the room-temperature electrical conductivity be 1.2 x 103 (ohm-m)-1. The concentration of B […]
On the basis of the photomicrograph (i.e., the relative amounts On the basis of the photomicrograph (i.e., the relative amounts of the microconstituents) for the lead–tin alloy shown in Figure and the Pb–Sn phase diagram (Figure), estimate the composition of the alloy, and then compare this estimate with the composition given in the figure legend […]
Sketch the repeat structure for each of the following alternatin copolymers: (a) Poly (butadiene-chloroprene), (b) Poly (styrene-methyl methacrylate), and (c) poly(acrylonitrile-vinyl chloride).
Some aircraft component is fabricated from an aluminum alloy tha Some aircraft component is fabricated from an aluminum alloy that has a plane strain fracture toughness of 35MPavm (31.9 ksivin). It has been determined that fracture results at a stress of 250MPa (36,250psi) when the maximum (or critical) internal crack length is 2.0 mm (0.08 […]
On the basis of ionic charge and ionic radii given On the basis of ionic charge and ionic radii given in Table 12.3, predict crystal structures for the following materials: (a) CsI, (b) NiO, (c) KI, and (d) NiS. Justify yourselections.